How to fill your Butane lighters

CAUTION: Both lighter fuels, butane gas and petroleum oil are
extremely flammable. Fill Butane or Fluid in well ventilated area and never
attempt to refill near heat source, sparks or flame. Be sure ignition system
can not be operated.

STEP1

Before refilling lighter, drain air out of the gas tank
by pressing down the inlet valve with a small screw drive or pen. You will hear
a hissing sound when air or remaining gas let air out of the gas tank.

STEP2

Shake butane gas canister well before injecting butane
gas.

STEP3

Fill with lighter in an upside-down position, Put nozzle
tip of butane canister directly on inlet valve opening and press down firmly
for 2-3 seconds.

STEP4

Lighter is sufficiently filled when spray
back is occurred. A sufficient gas filling will take approximately 2 seconds.
To be sure the lighter is fully filled, press down slightly the inlet valve
with a small screw driver or pen, and you will see butane gas escape from inlet
valve. Repeat Step 1, 2 & 3 if necessary.

Precautions For
Butane Gas Filling

·    Right after refilling, lighter itself is cold which
causes erratic flame or misfire. Wait at least 2-3 minutes before attempting to
ignite the lighter. This allows butane gas in the lighter reach room
temperature.

·    Right after refilling, wait at least 2-3 minutes to allow
enough time for excess butane gas in vicinity to dissipate. Ignite lighter away
from face.

·    Turn adjuster screw or adjuster lever to near (-) low
position before attempting to ignite the lighter and carefully adjust flame to
desired height. Excessively large flame is dangerous.