Tuning your lighter.

Here below are explanations for adjusting
appropriate flame height

Butane
Gas Lighter

·
Flame height can be
adjusted by turning adjustable screw or adjustable lever to (+) high for a long
flame or to (-) low for a short flame.

·
The flame height of all
Sarome lighters is pre-set for reliable use. An
adjustable stopper is installed to prevent turning flame adjuster beyond the
preset maximum and minimum.

·
Do not adjust flame
height frequently after setting the adjuster properly. Refill lighter when
flame height decreases as mostly due to low gas.

·
Always ignite
electronic and turbo lighters slowly to avoid misfire.

·
For safety, we
recommend to set flame height for flint and electronic lighters at 2cm-3cm
long.

Locations of flame height adjuster may vary,

on lighter bottom as shown in left or on top as shown in right

Turbo
Lighter

·
A Turbo lighter has an
internal gas combustion system which turns gas energy to heat power to generate
complete gas burning, resulting in high temperature, blue flame which is
difficult to recognize in daylight. Precautions are required to handle.

·
Most of turbo lighter
either has a metal mesh or a catalyzed coil installed on top of burner
cylinder. When a flame is generated, these parts become red. The catalyzed coil
heats up quickly and retains heat to re-ignite butane gas coming from tank even
though flame is out.

·
A flame adjustment
should be made according to the incandescence condition of metal mesh or
catalyzed coil. See photos on the right.

·
Never touch or remove the metal mesh or the catalyzed
coil with a cigarette, fingers, screw driver or object.

Oil
lighter

·
When wick becomes
short, pull it up with pliers and adjust to necessary length.

·
When wick is longer
than required, flame becomes high and it is dangerous.

·
Lighter has a short
flame or is difficult to ignite when wick becomes black from carbon. Pull wick
up by 5mm and cut it with scissors. It is dangerous when wick is longer than
required.